|
Home
Manufactures
ConZerv
Crompton
Texmate
Meters
Wilbac Meter
Meter Types
Single Phase
Switchboard
Three Phase
Switchboard
Three Phase
Demand
Watt
Hour Meter
Bargains
Meter
Sensors
Current
Transformers
Potential
Transformers
Salzer
Switches
Temperature
Measurement
Ordering
Information
| |
Watthour Meter. Single
Phase, Amps, Volts and KWH.
2 or 3 wire
Kilowatt Hour Meter from Texmate.
|
The DI Series Kilowatt hour meter is ready to install in a
convenient panel cutout size.
A DIN style 98x46mm holds the DI50E
meter with the IOW2 signal conditioner with a 5 digit accuracy of 0.1%. This
meter is a processor, not a counter, and comes complete with system calibration, 1 solid core current transformer with a 1" window,
any amperage ready for installation. Works on Wye or
Delta systems, neutral not required. On board meter memory holds data even after a power
outage, with a large 0.56" display. Re-settable or continuous running for
your convenience. Powered by 120VAC standard, DC supply optional
|
|
DI50E
Single Phase Meter
Completely calibrated and configured for your
single phase 2 or 3 wire system. Provide Amp service 100-200 400 amp etc. and
the system voltage to complete the model number. Includes 1 solid core CT
1" ID Window.
1ea.DI50E-DP1-PS1-IOW2(300V)-Amps, Volts, KWH $315.00ea
DI50E Sheet
|
|
DI503E Single phase
Controller
Complete Instantaneous system information
for a single phase 2 or 3 wire system. Five digit, Triple Display measuring
Volt, Amps, Kilowatt hours, Frequency, Watts, Kilowatts, Power Factor, load
monitoring up to 600 VAC. Completely configured with 3
selectable of 3 primary displays. Provide amp service 100-200 or 400 amp
etc. and the system voltage to complete the model number. Includes 1 solid
core CT w/1"ID Window.
Options include RS232 and RS485
Communications
1ea.DI503E-DR3-PS1-IOW2
(300V) Amps, Volts, KWH
$400.00ea
DI503E Sheet
|
 |
Options for the DI503E Series Meters
1ea. DC Power Supply $35.00
1ea, Green Display, replacing Red $35.00
Up to 4 relay outputs with programmable upper and lower limits. Timers on set points Dual 4-20mA or 0-10V 16 bit analog output RS 232 or RS 485 DeviceNet/Modbus
Direct serial printer output
Assorted Current Transformer are
available.
Transformers
|
Caution
Serious injury can result from
electrical shock. Be sure to turn off the electrical
power before installing any meter.
Fire can result from loose electrical connections.
Ensure that all electrical connections are
secure. If you do not understand theses
instructions hire an experienced electrician
to install the meter for you. Help is also
available from the factory buy phone or email.
In most localities a permit and
inspection is required to install the meters.
|
